Speedometer Malfunction [07/2020 - ]: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check if CAN communication DTCs are output.
Refer to DIAGNOSIS SYSTEM [07/2020 - 10/2022] , or refer to DIAGNOSIS SYSTEM [10/2022 - 10/2023] , or refer to DIAGNOSIS SYSTEM [10/2023 - ]
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - 10/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - ]
Result:
A
See step 2
- Check if CAN communication DTCs are output.
- CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
- Check if electronically controlled brake system DTCs are output.
Chassis > Brake/EPB > Trouble Codes
Chassis > Brake Booster > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2020 - 12/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [12/2021 - ]
Result:
A
See step 3
- Check if electronically controlled brake system DTCs are output.
- PERFORM ACTIVE TEST USING GTS
- Perform the Active Test according to the display on the GTS.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Speedometer Operation (0km/h, 0MPH) Speedometer
(0 km/h, 0 mph)ON When the active test is performed, the multi-information display may operate. This is not a malfunction. Speedometer Operation (40km/h, 40MPH) Speedometer
(40 km/h, 40 mph)ON - When the active test is performed, the multi-information display may operate. This is not a malfunction.
- The value displayed on the speedometer may deviate.*
Speedometer Operation (80km/h, 80MPH) Speedometer
(80 km/h, 80 mph)ON - When the active test is performed, the multi-information display may operate. This is not a malfunction.
- The value displayed on the speedometer may deviate.*
Speedometer Operation (120km/h, 120MPH) Speedometer
(120 km/h, 120 mph)ON - When the active test is performed, the multi-information display may operate. This is not a malfunction.
- The value displayed on the speedometer may deviate.*
Speedometer Operation (160km/h, 160MPH) Speedometer
(160 km/h, 160 mph)ON - When the active test is performed, the multi-information display may operate. This is not a malfunction.
- The value displayed on the speedometer may deviate.*
Speedometer Operation (200km/h, 200MPH) Speedometer
(200 km/h, 200 mph)ON - When the active test is performed, the multi-information display may operate. This is not a malfunction.
- The value displayed on the speedometer may deviate.*
Speedometer Operation (240km/h, 240MPH) Speedometer
(240 km/h, 240 mph)ON When the active test is performed, the multi-information display may operate. This is not a malfunction. - *: For the tolerance of each Speed Signal Input Active Test, refer to On-vehicle Inspection.
Refer to ON-VEHICLE INSPECTION [07/2020 - ]
HINT:
When the value of the Active Test is more than or equal to the speedometer upper limit, the indicated speed stops at the upper limit.
Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (0km/h, 0MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (40km/h, 40MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (80km/h, 80MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (120km/h, 120MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (160km/h, 160MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (200km/h, 200MPH) Body Electrical > Combination Meter > Active Test
Tester Display Speedometer Operation (240km/h, 240MPH) Result
Result Proceed to Active Test can be performed correctly A Active Test cannot be performed correctly B
Result:
A
REPLACE NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to REMOVAL [07/2020 - 10/2022] , or refer to REMOVAL [10/2022 - ]
Result:
B
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [07/2020 - 10/2022] , or refer to REMOVAL [10/2022 - ]
- Perform the Active Test according to the display on the GTS.