LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza LE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior Panels / Trim - Service Information >> Roof Sunshade >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

  1. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH 

    Refer to REMOVAL [10/2022 - ]

  2. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  3. REMOVE FRONT SLIDING ROOF HOUSING MOUNTING BRACKET LH 
    1. Remove the 2 bolts and front sliding roof housing mounting bracket LH.
      GTY1012067Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT SLIDING ROOF HOUSING MOUNTING BRACKET RH 

    HINT: 

    Use the same procedure described for the LH side.

  5. REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH 
    1. Remove the 2 bolts and rear sliding roof housing mounting bracket LH.
      GTY1012066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH 

    HINT: 

    Use the same procedure described for the LH side.

  7. REMOVE ROOF SUNSHADE HOUSING ASSEMBLY 
    1. Remove the 7 nuts and roof sunshade housing assembly.
      GTY1013506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not damage the roof sunshade housing assembly or vehicle interior.

  8. REMOVE REAR ROOF HEADLINING GARNISH 

    HINT: 

    Perform this procedure only when replacement of the rear roof headlining garnish is necessary.

    1. Disengage the 4 clips to remove the rear roof headlining garnish.
      GTY1013249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals