Installation [03/2019 - ]: Procedure

1. Position front suspension member lower protector (1).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Replace 16 mm bolts (2).
3. Tighten the 16 mm bolts (2).

   Torque: 56 N.m (571 kgf/cm, 41 ft.lbf) 

4. Using SST, tighten the 16 mm bolts (2) an additional 45°.
   • SST: 09900-WA010 

   HINT: 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Example
   *b	Before Tightening
   *c	After Tightening
   *d	Magnetic Portion

   • The magnetic portion is used to secure the gauge to the vehicle.
   • After first adjusting the needle of the gauge to 0°, tighten to the specified angle.
   • Perform the work procedure carefully so that the gauge, etc. does not become tilted.
5. Tighten screws (arrows).

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

1. Position front floor cover (1).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Tighten screws (arrows).

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

1. Insert the front fender splash front shield LH (1) at the side.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Tighten screws (arrows).

   Torque: 2.6 N.m (27 kgf/cm, 23 in.lbf) 

HINT: 

Use the same procedure as for the LH side.

1. Guide the No. 1 engine under cover assembly (1) in and position it.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Tighten screws (arrows).

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf)