Removal [07/2020 - ]: Procedure

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- for B46:
  Refer to REMOVAL [07/2020 - ]
- for B58:
  Refer to REMOVAL [03/2019 - ]

REMOVE FRONT FENDER LINER LH

Remove the 13 screws, clip and front fender liner LH (1).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE HOOD TO RADIATOR SUPPORT SEAL

Remove the hood to radiator support seal (1).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FRONT FENDER UPPER PROTECTOR LH

Remove the clips (1) and clips (2).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FRONT FENDER UPPER PROTECTOR RH
HINT:

Use the same procedure as for the LH side.

REMOVE FRONT BUMPER ASSEMBLY

Apply protective tape as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Remove the T20 screws (1).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Perform the operations on the left and right side.

Disengage front bumper assembly from the clamp (2).
HINT:

Perform the operations on the left and right side.

Disconnect the connector (1).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Perform the operations on the left and right side.

Disengage the clamp (2).
HINT:

Perform the operations on the left and right side.

Remove the screws (arrows) on the front bumper assembly.

Remove the bolts (1).

Disengage the clamps (1) and guides (2) to separate the front bumper assembly.

Disengage the fasteners to remove the front bumper assembly (1).