Brake Shoes &/Or Pads: Remove & Replace
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| All | | 1.8 | | B |
| Front or Rear,Both Sides | | 1.0 | | B |
| Combination Procedure: BRAKE HOSE: Replace: |
| Each Additional | | 0.2 | | B |
| One | Includes: Bleed Brakes. | 0.3 | | B |
| Combination Procedure: CALIPER: Overhaul: |
| One | Includes: Bleed Brakes.
Includes: Additional time for use of scan tool to perform this procedure. | 0.7 | | B |
| Combination Procedure: CALIPER: Replace: |
| One | | 0.3 | | B |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: |
| | 0.5 | | B |
| Combination Procedure: DISC ROTOR: Correct: |
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | | B |
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: |
| Each | | 0.1 | | B |
| Combination Procedure: DISC ROTOR: Replace: |
| Each | | 0.1 | | B |
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: |
| Brake Pad Replacement Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.2 | | B |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: |
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | | B |
| Combination Procedure: WHEEL BEARING: Replace: |
| Front,One Side | | 0.7 | | B |
| Rear,One Side | | 6.6 | | B |