LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Sequoia TRD Pro >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats (Service Information) >> FRONT SEAT ASSEMBLY (for Manual Seat) >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2019 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - ] ).

  3. REMOVE FRONT SEAT HEADREST ASSEMBLY 
  4. REMOVE INNER SEAT TRACK COVER RH 
    1. Operate the seat track adjusting handle to move the seat to the foremost position.
    2. Disengage the 2 claws and remove the inner seat track cover RH.
      GTY762017Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE OUTER SEAT TRACK COVER RH 
    1. Disengage the 2 claws and remove the outer seat track cover RH.
      GTY773266Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT SEAT ASSEMBLY RH 
    1. Remove the 2 bolts.
      GTY773265Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Operate the seat track adjusting handle to move the seat to the rearmost position.
    3. Remove the 2 bolts.
      GTY762019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Operate the seat track adjusting handle to move the seat to the center position.
    5. Disconnect the seat wire connectors under the seat.
    6. Remove the front seat assembly RH.
      NOTE:

      Be careful not to damage the vehicle body.

scientia non olet · About LEMON Manuals