LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Sequoia TRD Pro >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats (Service Information) >> FRONT SEAT ASSEMBLY (for Manual Seat) >> Removal [08/2015 - 08/2017] >> Procedure

Removal [08/2015 - 08/2017]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - 08/2017] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2017] ).

  3. REMOVE FRONT SEAT HEADREST ASSEMBLY 
  4. REMOVE SEAT TRACK COVER INNER LH 
    1. Operate the seat track adjusting handle to move the seat to the foremost position.
    2. Disengage the 2 claws and remove the seat track cover.
      GTY604030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE SEAT TRACK COVER LH 
    1. Disengage the 2 claws and remove the seat track cover.
      GTY543754Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT SEAT ASSEMBLY LH 
    1. Remove the 2 bolts.
      GTY568133Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Operate the seat track adjusting handle to move the seat to the rearmost position.
    3. Remove the 2 bolts.
      GTY568135Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Operate the seat track adjusting handle to move the seat to the center position.
    5. Disconnect the seat wire connectors under the seat.
    6. Remove the front seat.
      NOTE:

      Be careful not to damage the vehicle body.

scientia non olet · About LEMON Manuals