LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Sequoia TRD Pro >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostics - Introduction (1 Of 2) >> Meter / Gauge System >> Customize Parameters [08/2019 - ] >> Procedure

Customize Parameters [08/2019 - ]: Procedure

  1. CUSTOMIZE METER / GAUGE SYSTEM 
    1. Customizing with Techstream
      NOTE:
      • When the customer requests a change in a function, first make sure that the function can be customized.
      • Be sure to make a note of the current settings before customizing.
      • When troubleshooting a function, first make sure that the function is set to the default setting.
      1. Connect the Techstream to the DLC3.
      2. Turn the engine switch on (IG).
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting / Warning
      5. Select the setting by referring to the table below.
        WARNING

        Display (Item) Default Content Setting
        Key Remind Sound Slow To change frequency of key reminder buzzer Normal/Slow/Fast
        Driver Side Seatbelt Warning Buzzer ON To change setting of driver side seat belt warning buzzer ON/OFF
        Front Passenger Side Seatbelt Warning Buzzer ON To change setting of front passenger side seat belt warning buzzer ON/OFF
    2. Customizing with the combination meter assembly
      1. Turn the engine switch on (IG).
      2. Enter the following menus: Settings.
        • Language
        • Units
        • Switch Settings
        • Drive Info 1
        • Drive Info 2
        • Pop-Up Display
        • Default Settings
scientia non olet · About LEMON Manuals