Installation [08/2017 - ]: Procedure

INSTALL COMBINATION METER ASSEMBLY
1. Connect the 2 connectors and attach the wire harness clamp.
2. Install the combination meter assembly with the 4 screws.
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 35 [08/2017 - 08/2018] , or refer to PROCEDURE - Step 36 [08/2018 - 08/2019] , or refer to PROCEDURE - Step 39 [08/2019 - ]
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 44 [08/2017 - 08/2018] , or refer to PROCEDURE - Step 45 [08/2018 - 08/2019] , or refer to PROCEDURE - Step 48 [08/2019 - ]
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 46 [08/2017 - 08/2018] , or refer to PROCEDURE - Step 47 [08/2018 - 08/2019] , or refer to PROCEDURE - Step 50 [08/2019 - ]
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 45 [08/2017 - 08/2019] , or refer to PROCEDURE - Step 47 [08/2019 - ]
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 47 [08/2017 - 08/2019] , or refer to PROCEDURE - Step 49 [08/2019 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2017 - 08/2018] , or refer to INITIALIZATION [08/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]

Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [08/2017 - 08/2019] , or refer to OPERATION CHECK [08/2019 - ]