Installation [08/2015 - 08/2017]: Procedure

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector and attach the wire harness clamp.
2. Install the combination meter assembly with the 4 screws.
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 45
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 54
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 56
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 46
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 48
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2017] ).

Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
CHECK SRS WARNING LIGHT
(Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2017] )