Removal [11/2018 - ]: Procedure
- REMOVE TORQUE VECTORING DIFFERENTIAL CARRIER ASSEMBLY (for Torque Vectoring Differential)
Refer to REMOVAL [11/2018 - ]
- REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY (except Torque Vectoring Differential)
Refer to REMOVAL [11/2018 - ]
- REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
- Using SST, remove the rear No. 1 differential mount cushion.
- SST: 09316-12010
- SST: 09570-24011
*1 Rear Suspension Member Sub-assembly - - *a Turn *b Hold Turning Direction Front of Vehicle SST Bolt Position - - NOTE:- Do not bring SST into contact with the rear suspension member sub-assembly.
- Before using SST, apply grease to SST bolt.
- Set SST in the correct direction.
- Do not tilt the bolt of SST.
- Do not reuse the rear No. 1 differential mount cushion.
- Using SST, remove the rear No. 1 differential mount cushion.