Caution / Notice / Hint
NOTE:
- When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
- If the millimeter wave radar sensor assembly has been replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Refer to ADJUSTMENT [11/2018 - 02/2019] , or refer to ADJUSTMENT [02/2019 - 12/2021]
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
- If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
for Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [11/2018 - 02/2019] , or refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [02/2019 - 12/2021]
for One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [11/2018 - 02/2019] , or refer to ADJUSTMENT (ONE TIME RECOGNITION) [02/2019 - 12/2021]
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2018 - ]
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]