Hybrid System Indicator Malfunction [02/2019 - 06/2020]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [02/2019 - 10/2019] , or refer to DIAGNOSIS SYSTEM [10/2019 - 06/2020]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

Refer to DIAGNOSIS SYSTEM [02/2019 - 10/2019] , or refer to DIAGNOSIS SYSTEM [10/2019 - 06/2020]

Result: 

A 

See step  2

1. Check if hybrid control system DTCs are output.

   for 2WD:

   Refer to DTC CHECK / CLEAR [11/2018 - 08/2020]

   for AWD:

   Refer to DTC CHECK / CLEAR [02/2019 - 10/2022]

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   Hybrid control system DTCs are not output.	A
   Hybrid control system DTC is output.	B

Result: 

B 

GO TO HYBRID CONTROL SYSTEM 

for 2WD:

Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2018 - 06/2020]

for AWD:

Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2019 - 06/2020]

Result: 

A 

See step  3

1. Using the Techstream, perform the Active Test.

   Refer to DATA LIST / ACTIVE TEST [11/2018 - 08/2020]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   HV System Indicator	Hybrid system indicator value	Min.: -512%, Max.: 511%	-512 to 511%	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   HV System Indicator

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as the hybrid system indicator indication.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE HYBRID VEHICLE CONTROL ECU 

Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020]

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [11/2018 - 10/2022]