Slip Indicator Light does not Come ON [02/2019 - 12/2021]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Select the Active Test on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [02/2019 - 12/2021]

   Chassis > ABS/VSC/TRAC > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly

4. Select the Data List on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [02/2019 - 12/2021]

   Chassis > ABS/VSC/TRAC > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Slip Indicator Light	Slip indicator light	ON or OFF	ON: Indicator light on OFF: Indicator light off	-

   Chassis > ABS/VSC/TRAC > Active Test 

   Active Test Display
   Slip Indicator Light

   Data List Display
   Slip Indicator Light

5. Check the operating condition of the slip indicator light when operating it using the Techstream.

   Result

   Result	Proceed to
   Slip indicator light in the Data List does not change using the Active Test.	A
   Slip indicator light in the Data List turns ON/OFF using the Active Test.	B

Result: 

A 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY. Refer to  REMOVAL [02/2019 - 10/2019]  , or refer to  REMOVAL [10/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - 12/2021] 

Result: 

B 

See step  2

1. Turn the ignition switch off.
2. Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream.

   Refer to DATA LIST / ACTIVE TEST [11/2018 - 08/2020] , or refer to DATA LIST / ACTIVE TEST [08/2020 - 10/2022]

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Slip Warning

3. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with the Techstream operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY. Refer to  REMOVAL [02/2019 - 10/2019]  , or refer to  REMOVAL [10/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - 12/2021] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]