Caution / Notice / Hint

NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration" after performing "Reset Memory".
Refer to UTILITY [12/2021 - ]

HINT:

When C137B-A2 and/or C137B-A3 is output together with C143A-7E and/or C143A-7F, inspect and repair the trouble areas indicated by C137B-A2 and/or C137B-A3 first.

for C137B-A2: Refer to DTC C137B-A2: Brake System Control Module "A" System Voltage System Voltage Low [12/2021 - ]

for C137B-A3: Refer to DTC C137B-A3: Brake System Control Module "A" System Voltage System Voltage High [12/2021 - ]