Caution / Notice / Hint

NOTE:

After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Refer to UTILITY [11/2018 - ]
Before performing troubleshooting, make sure to confirm that the battery voltage is normal.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
The system may store DTC C052F-14 due to a drop in battery voltage. If a DTC regarding low system supply power voltage is output at the same time, perform troubleshooting for that DTC first.
If the vehicle has stored DTC C052F-14 due a drop in battery voltage, it can be cleared by driving the vehicle at a speed of 15 km/h (9 mph) or more for 0.48 seconds or more and then clearing the DTCs using the GTS.