Removal [11/2018 - 02/2019]: Procedure

REMOVE REAR WHEEL
Refer to REMOVAL [11/2018 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD LH (for Gasoline Model)
Refer to PROCEDURE - Step 8
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (for Gasoline Model)
Refer to PROCEDURE - Step 9
REMOVE NO. 1 ENGINE UNDER COVER (for Gasoline Model)
Refer to PROCEDURE - Step 10
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for Gasoline Model)
Refer to PROCEDURE - Step 11
REMOVE FRONT FLOOR COVER LH (for Gasoline Model LH Side)
w/ Floor Under Cover:

Refer to PROCEDURE - Step 13
REMOVE FRONT FLOOR COVER RH (for Gasoline Model RH Side)
w/ Floor Under Cover:

Refer to PROCEDURE - Step 15
REMOVE NO. 2 FLOOR UNDER COVER (for Gasoline Model LH Side)
w/ Floor Under Cover:

Refer to PROCEDURE - Step 14
REMOVE NO. 1 FLOOR UNDER COVER (for Gasoline Model RH Side)
w/ Floor Under Cover:

Refer to PROCEDURE - Step 16
REMOVE LOWER NO. 2 CONTROL ARM COVER (w/ Cover)
See step 2

SEPARATE NO. 2 PARKING BRAKE WIRE ASSEMBLY

Disengage the 2 clamps.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut and separate the No. 2 parking brake wire assembly from the rear trailing arm assembly.

REMOVE REAR TRAILING ARM ASSEMBLY

Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTE:

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Wooden Block
*b	Transmission Jack

Remove the 3 bolts, nut and separate the rear trailing arm assembly from the rear axle carrier sub-assembly.

Remove the 2 bolts and rear trailing arm assembly.