Disassembly [10/2019 - ]: Procedure

1. Using a clip remover, remove the 6 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Detach the guide and remove the hood insulator.

HINT: 

Use the same procedure for the RH and LH sides.

Refer to PROCEDURE - Step 2

1. Detach the clamp and disconnect the windshield washer hose.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a thin-bladed screwdriver, detach the claw and remove the hood stay holder.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Tape the thin-bladed screwdriver tip before use.