LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 Prime XSE >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column - Service Information (PHEV) >> Steering Pad Switch >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

  1. INSTALL STEERING PAD SWITCH ASSEMBLY 
    1. Engage the 4 claws and 3 guide pins to install the steering pad switch assembly.
      GTY976389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 screws.
    3. Connect the connectors to the spiral cable sub-assembly.
  2. INSTALL STEERING WHEEL PAD ASSEMBLY 

    Refer to INSTALLATION [10/2022 - ]

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to INSTALLATION [10/2022 - ]

  4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL 

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [12/2021 - ]

  5. CHECK SRS WARNING LIGHT 

    Refer to OPERATION CHECK [06/2020 - ]

scientia non olet · About LEMON Manuals