Removal [06/2020 - 12/2021]: Procedure

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

REMOVE SERVICE PLUG GRIP
Refer to REMOVAL [06/2020 - 12/2021]
REMOVE NO. 2 INVERTER PROTECTOR
Refer to PROCEDURE - Step 8
REMOVE CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 9
CHECK TERMINAL VOLTAGE
Refer to PROCEDURE - Step 10
INSTALL CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 8
INSTALL NO. 2 INVERTER PROTECTOR
Refer to PROCEDURE - Step 14
REAR SEAT ASSEMBLY
Refer to REMOVAL [06/2020 - ]
REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
HINT:

Use the same procedure described for the LH side.

Refer to PROCEDURE - Step 6
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Refer to PROCEDURE - Step 1
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 9
REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
Refer to PROCEDURE - Step 20
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
- Remove the rear door opening trim weatherstrip RH so that the rear seat side garnish RH can be removed.
- Use the same procedure described for the LH side.
  Refer to REMOVAL [06/2020 - ]
REMOVE REAR SEAT SIDE GARNISH RH
HINT:

Use the same procedure described for the LH side.

Refer to PROCEDURE - Step 38
REMOVE TETHER ANCHOR BRACKET SET
Refer to PROCEDURE - Step 40
REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
Refer to PROCEDURE - Step 41
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Refer to PROCEDURE - Step 43
DISCONNECT AC CHARGER INLET CABLE
See step 19
REMOVE EV CHARGER LID SUB-ASSEMBLY
See step 20

REMOVE CHARGE LID LOCK WITH MOTOR ASSEMBLY

Disconnect the connector.

Detach the claw to remove the charge lid lock with motor assembly.