LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 Prime XSE >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Network Gateway Ecu - Service Information (PHEV) >> Network Gateway Ecu >> Removal [06/2020 - ] >> Procedure

Removal [06/2020 - ]: Procedure

  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [06/2020 - 12/2021] , or refer to REMOVAL [12/2021 - ]

  2. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure described for the LH side.

    Refer to PROCEDURE - Step 23 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 23 [12/2021 - ]

  3. REMOVE COWL SIDE TRIM BOARD RH 

    Refer to PROCEDURE - Step 27 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 27 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 27 [10/2022 - ]

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 28 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 28 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 28 [10/2022 - ]

  5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 

    Refer to PROCEDURE - Step 29 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 29 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 29 [10/2022 - ]

  6. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 30 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 30 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 30 [10/2022 - ]

  7. REMOVE ECU INTEGRATION BOX RH 
    1. Disconnect the connector.
      GTY986718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claw and disconnect the relay holder.
      GTY986368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Backside - -
      Protective Tape - -
    3. w/ TOYOTA Parking Assist-sensor System:
      GTY987268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ TOYOTA Parking Assist-sensor System
      1. Disconnect the 7 connectors.
    4. w/o TOYOTA Parking Assist-sensor System
      1. Disconnect the 6 connectors.
    5. Detach the clamp.
    6. Remove the nut and bolt.
      GTY985921Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Nut
    7. Detach the clamp and remove the ECU integration box RH.
      GTY986712Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NETWORK GATEWAY ECU 
    1. Detach the claw and remove the network gateway ECU.
      GTY986680Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals