Removal [06/2020 - 12/2021]: Procedure

PRECAUTION
Refer to PRECAUTION [06/2020 - ]

NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Refer to BEFORE DISCONNECTING BATTERY [06/2020 - 10/2022]
REMOVE REAR WHEEL
Refer to REMOVAL [06/2020 - ]
PERFORM REAR BRAKE PAD REPLACEMENT MODE
Refer to UTILITY [06/2020 - ]
DISABLE BRAKE CONTROL
Refer to PROCEDURE - Step 4
DRAIN BRAKE FLUID
NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Refer to PROCEDURE - Step 4

REMOVE REAR DISC BRAKE PAD

WARNING:

Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.
After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Hold the rear No. 1 disc brake cylinder slide pin and remove the bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Turn
*b	Hold

Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

Remove the rear No. 1 disc brake anti-squeal shim from the rear disc brake pad (inside and outside).

*1	Rear No. 1 Disc Brake Anti-squeal Shim
*2	Rear No. 2 Disc Brake Anti-squeal Shim
*3	Rear Disc Brake Pad
*4	Rear Disc Brake Pad Wear Indicator Plate

Remove the rear No. 2 disc brake anti-squeal shim from the rear disc brake pad (inside and outside).
Remove the rear disc brake anti-squeal shim from the rear disc brake pad (outside).

Remove the rear disc brake pad wear indicator plate from each rear disc brake pad.