LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 Prime SE >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (A25A-FXS) - Service Information (PHEV) >> Oil Pressure And Temperature Sensor >> Removal [06/2020 - ] >> Procedure

Removal [06/2020 - ]: Procedure

  1. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH 

    Refer to PROCEDURE - Step 11 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 11 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 11 [10/2022 - ]

  2. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH 

    Refer to PROCEDURE - Step 12 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 12 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 12 [10/2022 - ]

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 13 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 13 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 13 [10/2022 - ]

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 14 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 14 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 14 [10/2022 - ]

  5. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR 
    1. Disconnect the oil pressure and temperature sensor connector.
    2. Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
      GTY928336Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals