Removal [06/2020 - ]: Procedure

REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 11 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 11 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 11 [10/2022 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 12 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 12 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 12 [10/2022 - ]
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 13 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 13 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 13 [10/2022 - ]
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 14 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 14 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 14 [10/2022 - ]
DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1
DRAIN ENGINE OIL
Refer to PROCEDURE - Step 2 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 2 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 2 [10/2023 - ]

REMOVE OIL COOLER ASSEMBLY

Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the oil cooler assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 1 Water By-pass Hose
*2	No. 2 Water By-pass Hose

Remove the 4 bolts and oil cooler assembly from the cylinder block sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 oil cooler gaskets from the oil cooler assembly.

Remove the oil control valve filter from the cylinder block sub-assembly.