Inspection [06/2020 - ]: Procedure
- CHARGE LID LOCK WITH MOTOR ASSEMBLY
- Check the operation of the charge lid lock with motor assembly.
*a Component without harness connected
(Charge Lid Lock With Motor Assembly)*b A *c Lever - Apply auxiliary battery voltage to the charge lid lock with motor assembly connector, and check that the charge lid lock with motor assembly operates smoothly as follows.
OK
Auxiliary Battery Connection Specified Condition Auxiliary battery positive (+) - 1 (B)
Auxiliary battery negative (-) - 2 (E)Shaft Operation - Measure the shaft stroke.
Standard
Area Condition Specified Condition A Lever pulled 11 mm (0.433 in.)
- Apply auxiliary battery voltage to the charge lid lock with motor assembly connector, and check that the charge lid lock with motor assembly operates smoothly as follows.
- Check the operation of the charge lid lock with motor assembly.