On-Vehicle Inspection [11/2018 - ]: Procedure
- INSPECT HOOD SUB-ASSEMBLY
- Check that the clearance measurements of areas A to K are within the standard ranges.
Standard Clearance
Area Measurement Area Measurement A 1.85 to 5.85 mm (0.0728 to 0.2303 in.) B
(Reference)8.05 mm (0.317 in.) C 1.85 to 5.85 mm (0.0728 to 0.2303 in.) D -1.85 to 2.15 mm (-0.0728 to 0.0846 in.) E
(Reference)7.95 mm (0.313 in.) F 3.5 to 6.5 mm (0.138 to 0.256 in.) G 1.7 to 4.7 mm (0.0669 to 0.1850 in.) H 3.5 to 6.5 mm (0.138 to 0.256 in.) I 0.4 to 3.4 mm (0.0157 to 0.1339 in.) J 2.8 to 5.8 mm (0.110 to 0.228 in.) K -1.8 to 1.2 mm (-0.0709 to 0.0472 in.) - - HINT:
If the result is not as specified, adjust the hood sub-assembly.
Refer to ADJUSTMENT [11/2018 - ]
- Check that the clearance measurements of areas A to K are within the standard ranges.