LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Video System - Service Information >> Front Door Speaker >> Removal [11/2018 - ] >> Procedure

Removal [11/2018 - ]: Procedure

  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH 

    Refer to PROCEDURE - Step 6 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 6 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 6 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 6 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]

  2. REMOVE FRONT DOOR ASSIST GRIP COVER LH 

    Refer to PROCEDURE - Step 7 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 7 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 7 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 7 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 7 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 7 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 7 [10/2023 - ]

  3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) 

    Refer to PROCEDURE - Step 8 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 8 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 8 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 8 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 8 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 8 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 8 [10/2023 - ]

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) 

    Refer to PROCEDURE - Step 11 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 11 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 11 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 11 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 11 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 11 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 11 [10/2023 - ]

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 14 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 14 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 14 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 14 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 14 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 14 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 14 [10/2023 - ]

  6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY 
    NOTE:

    Do not touch the cone part of the speaker.

    1. Disconnect the connector.
      GTY921018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/o Woofer *B w/ Woofer
      Rivet Connector
    2. Put a 5 mm (0.197 in.) drill bit into a drill.
    3. Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.
      NOTE:

      Tape the 5 mm (0.197 in.) drill bit to prevent the drill bit from going too deep.

      Standard

      Area Specified Condition
      a 4 mm (0.157 in.)
    4. Lightly press the drill against the 3 rivets, drill off the flanges of the 3 rivets and remove the front No. 1 speaker assembly.
      WARNING:

      Be careful of the drilled rivet as it may become hot.

      NOTE:
      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.
    5. Continue drilling and push out the remaining rivet fragments.
    6. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.
scientia non olet · About LEMON Manuals