Typical Enabling Conditions
CASE 1
| Monitor runs whenever the following DTCs are not stored | C0501 (Case 4): Wheel speed sensor (FL) range/performance C0502: Wheel speed sensor (FL) voltage circuit open C137D: Brake system voltage input out of range high C14E1: Wheel speed sensor (FL) voltage circuit low |
| Both of the following conditions are met | - |
| Command to wheel speed sensor power supply | On |
| +BS voltage | 17.4 V or less |
CASE 2
| Monitor runs whenever the following DTCs are not stored | None |
| Power supply for wheel speed sensor | Off |