Removal [12/2021 - 10/2022]: Procedure

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Refer to PRECAUTION [08/2020 - ]

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]

REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
Refer to REMOVAL [12/2021 - 10/2022]

REMOVE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY

Slide the clip and disconnect the No. 2 reservoir hose from the brake booster with accumulator pump assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a union nut wrench, remove the brake actuator tube.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.

Disengage the 3 clamps.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut, brake booster with accumulator pump assembly, brake booster pump bushing and brake actuator case collar.

REMOVE NO. 2 WIRE CLAMP BRACKET

HINT:

Perform this procedure only when replacement of the No. 2 wire clamp bracket is necessary.

Using a 5 mm long hexagon socket wrench, remove the bolt and No. 2 wire clamp bracket.

REMOVE NO. 1 BRAKE POWER SUPPLY BRACKET

HINT:

Perform this procedure only when replacement of the No. 1 brake power supply bracket is necessary.

Using a 5 mm long hexagon socket wrench, remove the 2 bolts and No. 1 brake power supply bracket.

REMOVE NO. 2 BRAKE POWER SUPPLY BRACKET

HINT:

Perform this procedure only when replacement of the No. 2 brake power supply bracket is necessary.

Using a 5 mm long hexagon socket wrench, remove the 2 bolts and No. 2 brake power supply bracket.