Removal [08/2020 - 12/2021]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [08/2020 - ]
NOTE:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2018 - ]
- REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to REMOVAL [08/2020 - 12/2021]
- REMOVE NO. 1 AIR DUCT (for TMC Made)
Refer to PROCEDURE - Step 19
- REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY (for TMMC Made)
Refer to PROCEDURE - Step 20
- REMOVE STOP LIGHT SWITCH ASSEMBLY
Refer to REMOVAL [11/2018 - ]
- REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Refer to PROCEDURE - Step 3
- DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY
- REMOVE BRAKE PEDAL RETURN SPRING
- REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
Refer to REMOVAL [08/2020 - 10/2022]
- REMOVE PUSH ROD PIN
- REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
- REMOVE BRAKE PEDAL PAD
- Remove the brake pedal pad from the brake pedal support assembly.