Installation [11/2018 - ]: Procedure

1. Install the brake pedal pad to the brake pedal support assembly.

1. Install the brake pedal support assembly with the 4 nuts.

   Torque: 12.7 N.m (130 kgf/cm, 9 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. w/ clip:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the 2 clips.

1. Apply lithium soap base glycol grease to the push rod pin.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Lithium Soap Base Glycol Grease

2. Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
   NOTE:

   Be sure to install the push rod pin in the correct direction.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to INSTALLATION [11/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - 10/2022] , or refer to INSTALLATION [10/2022 - ]

1. Install the brake pedal return spring to the brake pedal support assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

   Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Connect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Connect the 2 wire harness clamps to the brake pedal support assembly.

Refer to PROCEDURE - Step 1

Refer to INSTALLATION [11/2018 - ]

Refer to PROCEDURE - Step 7

Refer to PROCEDURE - Step 8

Refer to INSTALLATION [11/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - ]

Refer to ADJUSTMENT [11/2018 - 12/2021] , or refer to ADJUSTMENT [12/2021 - ]