LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 LE, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information (1 Of 2) >> BRAKE MASTER CYLINDER (w/ Vacuum Brake Booster) >> Reassembly [11/2018 - ] >> Procedure

Reassembly [11/2018 - ]: Procedure

  1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER 
    1. Install the brake master cylinder reservoir strainer to the brake master cylinder reservoir assembly.
  2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
    1. Install the brake master cylinder reservoir filler cap assembly to the brake master cylinder reservoir assembly.
  3. INSTALL MASTER CYLINDER RESERVOIR GROMMET 
    1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.
      GTY894817Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Lithium Soap Base Glycol Grease
    2. Install the 2 master cylinder reservoir grommets to the brake master cylinder body.
  4. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Secure the brake master cylinder body in a vise.
      NOTE:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder body.

    2. Install the brake master cylinder reservoir assembly to the brake master cylinder body.
      NOTE:

      Do not drop the brake master cylinder reservoir assembly.

  5. INSTALL BRAKE MASTER CYLINDER RING PIN 
    1. Using a 5 mm pin punch and a hammer, tap in the brake master cylinder ring pin to secure the brake master cylinder reservoir assembly.
      GTY881097Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the brake master cylinder sub-assembly from the vise.
scientia non olet · About LEMON Manuals