Removal [02/2019 - 10/2019]: Procedure

PRECAUTION
NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]
REMOVE DECK BOARD ASSEMBLY (for HV Model)
Refer to PROCEDURE - Step 2
REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)
Refer to PROCEDURE - Step 3
REMOVE BATTERY HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 4
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
- for A25A-FKS:
  Refer to PROCEDURE - Step 2
- for A25A-FXS:
  Refer to PROCEDURE - Step 5
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2019 - 10/2019]
REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 8
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 2
REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [11/2018 - 12/2021]
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 14
REMOVE NAVIGATION ECU WITH BRACKET (w/ Navigation System)
Refer to PROCEDURE - Step 5

REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

Place a hand at the rear side of the center register, detach the hazard warning signal switch assembly claw and push towards the rear of the vehicle.

HINT:

Press the hazard warning signal switch assembly from the top and bottom and detach it.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Press in this Direction

Disconnect the connector.