Brake Control Warning Light Remains ON [11/2018 - 02/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the Data List on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [11/2018 - 02/2019]

   Chassis > ABS/VSC/TRAC > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ECB Warning Light	Brake warning light / yellow (minor malfunction)	ON or OFF	ON: Warning light on OFF: Warning light off	ECB: Electronically Controlled Brake System

   Chassis > ABS/VSC/TRAC > Data List 

   Tester Display
   ECB Warning Light

4. Check the Techstream display condition of the brake warning light / yellow (minor malfunction).

   Result

   Result	Proceed to
   Display of the Data List remains OFF.	A
   Display of the Data List remains ON.	B

Result: 

A 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

B 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY. Refer to  REMOVAL [11/2018 - 02/2019]