Typical Malfunction Thresholds
C13DA (CASE 1-1)
| Both of the following conditions are met | - |
| Difference between servo pressure and target brake pressure | Higher than 1 to 4 MPa (10.2 to 40.8 kgf/cm2 , 145 to 580 psi) |
| Delay of servo pressure decrease | Higher than 0.3 to 4.056 seconds |
C13DA (CASE 1-2)
| Both of the following conditions are met | - |
| Difference between servo pressure and target brake pressure | Higher than 1 to 4 MPa (10.2 to 40.8 kgf/cm2 , 145 to 580 psi) |
| Delay of servo pressure decrease | Higher than 0.3 to 4.056 seconds |
C13DA (CASE 1-3)
| Difference between servo pressure and target brake pressure | Higher than 0.5 MPa (5.1 kgf/cm2 , 73 psi) |
C13DA (CASE 1-4)
| Difference between servo pressure and target brake pressure | Higher than 4 MPa (40.8 kgf/cm2 , 580 psi) |