On-Vehicle Inspection [11/2018 - ]: Procedure
- WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light / red (indicator), slip indicator light, VSC OFF indicator light, brake hold standby indicator light, downhill assist control indicator* and brake hold operated indicator light come on for approximately 3 seconds.
HINT:
If the warning lights and indicator lights does not illuminate or illuminates for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
*: w/ Downhill Assist Control
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light / red (indicator), slip indicator light, VSC OFF indicator light, brake hold standby indicator light, downhill assist control indicator* and brake hold operated indicator light come on for approximately 3 seconds.