Engine Oil Level Sensor Circuit [08/2020 - 10/2022]: Procedure

1. Remove the engine oil level sensor.

   For A25A-FKS:

   Refer to REMOVAL [11/2018 - ]

   For A25A-FXS:

   Refer to REMOVAL [11/2018 - ]

2. Inspect the engine oil level sensor.

   For A25A-FKS:

   Refer to INSPECTION [11/2018 - ]

   For A25A-FXS:

   Refer to INSPECTION [11/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE OIL LEVEL SENSOR 

For A25A-FKS:

Refer to REMOVAL [11/2018 - ]

For A25A-FXS:

Refer to REMOVAL [11/2018 - ]

Result: 

OK 

See step  2

1. Disconnect the G19 combination meter assembly connector.
2. Disconnect the C20 engine oil level sensor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G19-31 (OILW) - C20-1	Always	Below 1 Ω
   G19-31 (OILW) or C20-1 - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2018 - 10/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR