Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the fuel lid lock control cable assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Removal and installation of auxiliary battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Refer to PRECAUTION [11/2018 - 12/2021]
	Perform steering sensor zero point calibration	Lane control system	Refer to INITIALIZATION [11/2018 - 12/2021]
		Parking support brake system (for Gasoline model)*
		Pre-collision system
	Memorize steering angle neutral point	Parking assist monitor system	Refer to INITIALIZATION [11/2018 - 10/2022]
	Memorize steering angle neutral point	Panoramic view monitor system (for Gasoline model)	Refer to INITIALIZATION [11/2018 - 10/2022]
	Reset back door close position	Power back door system (for Gasoline model)	Refer to INITIALIZATION [11/2018 - 10/2023]
	Back door lock initialization	Power door lock control system	Refer to INITIALIZATION [11/2018 - ]
Position control ECU assembly (driver seat) (Including removal and installation) Reclining motor (Front seatback frame sub-assembly (driver seat)) (Including removal and installation) Slide motor (Front seat adjuster assembly (driver seat)) (Including removal and installation) Power seat lifter motor assembly (driver seat) (Including removal and installation) Lumbar support adjuster assembly (driver seat) (Including removal and installation) Power seat tilt motor assembly (driver seat) (Including removal and installation)	Initialize position control ECU	Front power seat control system (for Gasoline model with memory)	Refer to REGISTRATION [11/2018 - ]

*: When performing learning using the Techstream.

NOTE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.

WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL

System Name	See Procedure
Vehicle enrolled in Toyota Entune system or safety connect system	6 minutes
Vehicle not enrolled in Toyota Entune system and safety connect system	1 minute