On-Vehicle Inspection [09/2016 - ]: Procedure
- INSPECT HOOD SUB-ASSEMBLY
- Check that the clearance measurements of areas a through f are within each standard range.STANDARD CLEARANCE
Area Measurement Area Measurement a 1.45 to 5.45 mm (0.0571 to 0.215 in.) b -1.85 to 2.15 mm (-0.0728 to 0.0846 in.) c 3.05 to 7.05 mm (0.12 to 0.278 in.) d 1.85 to 5.85 mm (0.0728 to 0.23 in.) e 3.4 to 6.4 mm (0.134 to 0.252 in.) f -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
- Check that the clearance measurements of areas a through f are within each standard range.