Adjustment [09/2016 - ]: Procedure

INSPECT FRONT DOOR

Check that the clearance measurements of areas a through n are within each standard range.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD CLEARANCE

Area	Measurement	Area	Measurement
a	3.15 to 6.55 mm (0.124 to 0.258 in.)	b	2.85 to 6.85 mm (0.112 to 0.270 in.)
c	3.15 to 6.55 mm (0.124 to 0.258 in.)	d	1.65 to 5.65 mm (0.0650 to 0.222 in.)
e	3.15 to 6.55 mm (0.124 to 0.258 in.)	f	1.75 to 5.75 mm (0.0689 to 0.226 in.)
g	3.15 to 6.55 mm (0.124 to 0.258 in.)	h	1.55 to 5.55 mm (0.0610 to 0.219 in.)
i	2.5 to 6.5 mm (0.0984 to 0.256 in.)	j	-2.0 to 2.0 mm (-0.0787 to 0.0787 in.)
k	3.0 to 5.4 mm (0.118 to 0.213 in.)	l	-1.2 to 1.2 mm (-0.0472 to 0.0472 in.)
m	3.55 to 7.75 mm (0.140 to 0.305 in.)	n	2.6 to 5.6 mm (0.102 to 0.220 in.)

ADJUST FRONT DOOR

NOTE:

Make sure to turn the power switch off before adjusting the door lock strikers.

Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tighten the 4 hinge bolts on the vehicle body after adjustment.
Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)

Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.
Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)