DTC B2414: Steering Position Sensor [09/2016 - ]: Procedure

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs

Result

Proceed to
NEXT

Result:

NEXT

See step 2

CHECK FOR DTC

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes

OK

DTC B2414 is not output.

Result

Proceed to
OK
NG

Result:

OK

USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2016 - 05/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2019 - 07/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - 06/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2021 - ]

Result:

NG

See step 3

REPLACE STEERING SENSOR

Replace the steering sensor with a new or known good one.

Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]

Result

Proceed to
NEXT

Result:

NEXT

See step 4

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs

Result

Proceed to
NEXT

Result:

NEXT

See step 5

CHECK FOR DTC

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes

OK

DTC B2414 is not output.

Result

Proceed to
OK
NG

Result:

OK

END (STEERING SENSOR WAS DEFECTIVE)

Result:

NG

REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to REMOVAL [09/2016 - ]