Removal [07/2020 - ]: Procedure
- PRECAUTION WARNING:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [07/2020 - ]
- Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
NOTE:After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Refer to PRECAUTION [05/2019 - ]
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- REMOVE TONNEAU COVER ASSEMBLY
Refer to PROCEDURE - Step 3
- REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 4
- REMOVE REAR NO. 4 FLOOR BOARD
Refer to PROCEDURE - Step 5
- REMOVE REAR NO. 3 FLOOR BOARD
Refer to PROCEDURE - Step 6
- REMOVE REAR NO. 1 FLOOR BOARD
Refer to PROCEDURE - Step 7
- REMOVE DECK FLOOR BOX LH
Refer to PROCEDURE - Step 8
- REMOVE DECK FLOOR BOX RH
Refer to PROCEDURE - Step 9
- REMOVE DECK TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2
- REMOVE REAR DECK TRIM COVER
Refer to PROCEDURE - Step 11
- REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
Refer to PROCEDURE - Step 1
- REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
Refer to PROCEDURE - Step 3
- DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Refer to PROCEDURE - Step 4
- REMOVE REAR SEATBACK ASSEMBLY RH
Refer to PROCEDURE - Step 5
- REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 7
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 8
- REMOVE REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 16
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Refer to PROCEDURE - Step 19
- REMOVE REAR UNDER SIDE COVER RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 33
- REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 34
- REMOVE REAR PILLAR COVER RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 35
- REMOVE REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 36
- REMOVE NO. 1 TONNEAU COVER HOLDER CAP
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 37
- REMOVE TONNEAU COVER HOOK A
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 46
- REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 39
- REMOVE SPOT LIGHT COVER
- REMOVE SPOT LIGHT ASSEMBLY