Entire Combination Meter does not Operate [11/2015 -]: Procedure

1. Disconnect the F6 combination meter assembly (meter circuit plate) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F6-28 (ES) - Body ground	Always	Below 1 Ω
   F6-40 (EP) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F6-21 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   F6-22 (B) - Body ground	Power switch off	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE). Refer to  DISASSEMBLY [11/2015 -] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR