LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Prius 2020 Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Maintenance - Service Information) >> 2GR-FKS Battery >> Installation [04/2018 - ] >> Procedure

Installation [04/2018 - ]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL BATTERY 
    1. Install the battery to the vehicle.
    2. Install the No. 2 battery clamp to the battery clamp sub-assembly with the bolt.
      GTY836525Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      Torque: 18.5 N*m (189 kgf*cm, 14 ft.*lbf) 

    3. Connect the cable to the positive (+) battery terminal and tighten the nut.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Engage the 2 claws to install the battery terminal cap to the positive (+) battery terminal.
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    1. Connect the cable to the negative (-) battery terminal and tighten the nut.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [04/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

scientia non olet · About LEMON Manuals