Removal [12/2023 - ]: Procedure

Refer to REMOVAL [12/2023 - ]

Refer to PROCEDURE - Step 18

Refer to PROCEDURE - Step 19

Refer to PROCEDURE - Step 20

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 2 nuts and front stabilizer link assembly LH.

      HINT: 

      If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

1. Perform the same procedure as for the LH side.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 4 bolts and front stabilizer bar.

      HINT: 

      • The stabilizer bracket and bush are built onto the stabilizer bar.
      • If the bracket and/or bush detach from the bar, replace the bar.