Removal [12/2022 - 12/2023]: Procedure

Refer to REMOVAL [12/2022 - 12/2023]

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the bolt and disconnect the No. 1 discharge hose sub-assembly.
   2. Remove the O-ring from the No. 1 discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Remove in this Direction (1)		Remove in this Direction (2)
   	Remove in this Direction (3)	-	-

   1. Detach the claw and guide and remove the cooler condenser assembly as shown in the illustration.
      NOTE:

      Do not damage the cooler condenser assembly and radiator assembly when removing the cooler condenser assembly.