LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Mirai XLE >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge System - Diagnostic Codes (3 Of 3) & Symptom Tests >> Meter / Gauge System >> Speedometer Malfunction [11/2020 - 12/2023] >> Procedure

Speedometer Malfunction [11/2020 - 12/2023]: Procedure

  1. CHECK FOR DTC 
    1. Check for DTCs.

      Body Electrical > Combination Meter > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    Result: 

    GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2020 - 11/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 12/2022]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2022 - 12/2023] 

    Result: 

    See step  2

  2. CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) 
    1. Check for DTCs.

      Chassis > Brake/EPB > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    Result: 

    ELECTRONICALLY CONTROLLED BRAKE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2020 - 12/2023] 

    Result: 

    See step  3

  3. READ VALUE USING GTS (VEHICLE SPEED METER) 
    1. Using the GTS, read the Data List.

      Refer to DATA LIST / ACTIVE TEST [11/2020 - 12/2023]

      Body Electrical > Combination Meter > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -

      Body Electrical > Combination Meter > Data List 

      Tester Display
      Vehicle Speed Meter

      HINT: 

      • When the Data List values of the ECUs match, an internal malfunction of the combination meter assembly is suspected.
      • When the Data List values of the ECUs do not match, a signal output error of the brake actuator assembly (No. 2 skid control ECU) or an internal malfunction of the combination meter assembly is suspected.

      OK

      Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

    Result: 

    NG 

    See step  4

  4. READ VALUE USING GTS (VEHICLE SPEED) 
    1. Using the GTS, read the Data List.

      Refer to DATA LIST / ACTIVE TEST [11/2020 - 12/2023]

      Chassis > Brake/EPB > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Vehicle Speed Vehicle speed
      (Vehicle speed signal output to combination meter assembly)
      Min.: 0.0 km/h (0 mph), Max.: 6553.5 km/h (4072 mph) Vehicle stopped: 0.0 km/h (0 mph) When driving at constant speed: No large fluctuations

      Chassis > Brake/EPB > Data List 

      Tester Display
      Vehicle Speed

      OK

      Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

    Result: 

    NG 

    REPLACE BRAKE ACTUATOR ASSEMBLY (NO. 2 SKID CONTROL ECU). Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023]