Operating Light Control Rheostat does not Change Light Brightness [11/2020 - 11/2021]: Procedure

1. Using the GTS, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [11/2020 - 12/2023]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Light Control Switch (UP)	Light control rheostat up switch (Trip switch)	OFF/ON	OFF: Switch released ON: Switch pushed	-
   Light Control Switch (DOWN)	Light control rheostat down switch (Trip switch)	OFF/ON	OFF: Switch released ON: Switch pushed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Light Control Switch (UP)
   Light Control Switch (DOWN)

   OK

   Light control rheostat up or down switch condition displayed on the GTS changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021] 

Result: 

NG 

See step  2

Refer to INSPECTION [11/2020 - ]

Result

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [11/2020 - ] 

Result: 

OK 

See step  3

1. Disconnect the D41*1 or D43*2 combination meter assembly connector.
   1. *1: w/o Advanced Drive
   2. *2: w/ Advanced Drive
2. Disconnect the D7 trip switch connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   W/O ADVANCED DRIVE
   
   

   Tester Connection	Condition	Specified Condition
   D41-25 (TR) - D7-5 (RV)	Always	Below 1 Ω
   D41-26 (SW3) - D7-1 (E)	Always	Below 1 Ω
   D41-25 (TR) or D7-5 (RV) - Other terminals and body ground	Always	10 kΩ or higher
   D41-26 (SW3) or D7-1 (E) - Other terminals and body ground	Always	10 kΩ or higher

   W/ ADVANCED DRIVE
   
   

   Tester Connection	Condition	Specified Condition
   D43-11 (TR) - D7-5 (RV)	Always	Below 1 Ω
   D43-28 (SW3) - D7-1 (E)	Always	Below 1 Ω
   D43-11 (TR) or D7-5 (RV) - Other terminals and body ground	Always	10 kΩ or higher
   D43-28 (SW3) or D7-1 (E) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR