Odo/Trip Switch Malfunction [12/2023 - ]: Procedure

1. Using the GTS, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [12/2023 - ]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change Switch	ODO/TRIP switch (Trip switch)	OFF/ON	OFF: Switch released ON: Switch pushed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   ODO/TRIP Change Switch

   OK

   ODO/TRIP switch condition displayed on the GTS changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

NG 

See step  2

Refer to INSPECTION [11/2020 - ]

Result

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [11/2020 - ] 

Result: 

OK 

See step  3

1. Disconnect the D43*1 or D200*2 combination meter assembly connector.
   1. *1: w/ Front LiDAR Sensor
   2. *2: w/o Front LiDAR Sensor
2. Disconnect the D7 trip switch connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   W/ FRONT LIDAR SENSOR
   
   

   Tester Connection	Condition	Specified Condition
   D43-13 (ODO) - D7-9 (A/B)	Always	Below 1 Ω
   D43-28 (SW3) - D7-1 (E)	Always	Below 1 Ω
   D43-13 (ODO) or D7-9 (A/B) - Body ground	Always	10 kΩ or higher
   D43-28 (SW3) or D7-1 (E) - Body ground	Always	10 kΩ or higher

   W/O FRONT LIDAR SENSOR
   
   

   Tester Connection	Condition	Specified Condition
   D200-13 (ODO) - D7-9 (A/B)	Always	Below 1 Ω
   D200-26 (SW3) - D7-1 (E)	Always	Below 1 Ω
   D200-13 (ODO) or D7-9 (A/B) - Body ground	Always	10 kΩ or higher
   D200-26 (SW3) or D7-1 (E) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR