LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Mirai XLE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (3 Of 3) >> Roof Drip Side Finish Moulding >> Removal [11/2020 - ] >> Procedure

Removal [11/2020 - ]: Procedure

  1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH 
    1. GTY1016410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for Panoramic Moon Roof *B for Normal Roof
      1. Put protective tape around the center roof drip side finish moulding LH.
      2. Using moulding remover D, detach the clip and remove the center roof drip side finish moulding LH.
        NOTE:
        • Do not remove the No. 1 roof drip side finish moulding clip.
        • If a No. 1 roof drip side finish moulding clip is damaged or falls off, replace it with a new one.